Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Por um escritor misterioso
Descrição
I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan
Bambu Lab Slicer: Bambu Studio – All You Need to Know
Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum
Bambu Studio: How & WHY to use Support Overhang Shading. Also Orca! Bambu Lab P1P - P1S - X1C
Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Bambu Studio isn't generating supports for obvious overhangs · Issue #1578 · bambulab/BambuStudio · GitHub
Help with overhangs : r/BambuLab
How to do support structures for small round overhangs in Bambu Studio : r/BambuLab
Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
How to show Overhangs in Bambu Studio @BambuLab #bambustudio #3dprinting #3dslicer
Tuning overhangs - Bambu Studio - Bambu Lab Community Forum
Arc overhangs print, result and with settings on Bambu studio 1.7.1.62. It's my third test version with 2cm overhangs and I have not optimized my settings. : r/BambuLab
de
por adulto (o preço varia de acordo com o tamanho do grupo)
